180 Degree Flipping Machine Tool For Main Beam: Solving Welding Challenges in Semi - Trailer Production

180 degree flipping machine tool for large beams

1: Technical requirements of the demand side:

Hydraulic flip reset, suitable for workpiece length up to 17.5 meters, compatible with the production of side dump trucks

2: Supplier's Technical Completion Statement:

1: The above technical requirements of the demand side are fully met and complied with by the equipment provided by the supplier

Technical solution for the 180 degree flipping machine of the main beam

1: Main purpose and current situation analysis

When the semi-trailer beam is welded by submerged arc welding, the two corresponding surfaces of the beam need to be fully welded. After welding one side, the beam needs to be flipped 180 degrees before welding the other side. During this process, the traditional way of flipping the beam is to clamp it with a fixture by the crane and assist personnel in flipping it. This process has certain safety hazards and low efficiency, which increases the labor intensity of workers. The 180 degree flipping machine for large beams is remotely controlled by personnel to complete the flipping work, saving time and effort, and reducing the safety risks caused by personnel involvement in flipping.

2: Functional Introduction and Partial Detail Processing

1

2

3

4

3: Technical parameters and brief configuration

1

2

Total power of equipment: Greater than or equal to 4KW

3

Motor Model: YE Series-4

4

Flip cylinder model: 63 (cylinder diameter) * 300, 2 sets on each side, a total of 4 sets

5

Workpiece centering return oil cylinder model: 63 (cylinder diameter) * 400 per set

6

Equipment size (length, width, height mm): 10000 * 1760 * 680 (platform surface)

7

8

Maximum height drop of goose neck: 0mm

9

10

4: Power supply range

1

5: Safety and Protection

1

6: Random data

1

2

One copy of after-sales service manual

7: Scope of supply, scope of self provided by the demander, and installation conditions of the site

1

Host: 1 set

Including 6 sets of action oil cylinders, flipping device, and main structure

2

Hydraulic station: 1 set

1

L-HM-46

2

4-core 4-square

1: Concrete floor or hard floor

2: Ground tilt angle: less than 8 degrees